Nokia 4A0-C02 Quiz 13 Topic 4 Questions 61-65

Question: 1

If the device connected to PE-A in Metro A sends a frame to PE-A that requires replication within the VPLS which devices is PE-A responsible for replicating the frame to?

APE-A must replicate the frame to all devices participating in the VPLS

BPE-A must replicate the frame to all PEs within Metro A

CPE-A must replicate the frame to all devices in the Metro A

DAll of the above

Show Answer

Question: 2

Given the following output what is the most likely reason the SDP binding is operationally down? (Choose 2)

AThe sdp id is different on the far-end.

BLDP is disabled on the far-end.

CThe vc-id is different on the far-end.

DThe mesh-sdp is missing on the far-end.

EThe mesh-sdp is administratively shutdown on PEL

FThere is an MTU mismatch.

Show Answer

Question: 3

Assume a CE router is connected to the SAP of each PE. The arp cache of all CE routers is empty and the FDB for VPLS 300 is empty. The CE router connected to PE-A initiates a ping towards the CE router connected to PE-C. The ping is successful. Which of the following statements are true? (Choose 2)

AThe FDB on PE-A will contain entries for all CE routers.

BThe FDB on PE-B will contain an entry for the CE router connected to PE-A.

CThe FDB on PE-B will contain an entry for all CE routers.

DThe FDB on PE-C will contain entries for the CE router connected to PE-A and the CE router connected to PE-C.

Show Answer

Question: 4

Which SDP on R3 will MAC addresses be associated with for devices behind R2?

AIt depends if traffic is received via R4 or R1 from devices behind R2.

BThe devices cannot communicate based on the configuration in the diagram so there will be no mac address association.

CDevices behind R2 will be associated with the sdp between R3 and R1.

DDevices behind R2 will be associated with the sdp between R3 and R4.

Show Answer

Question: 5

The SAP on PE-A has been configured with dot1q encapsulation. The SAP on PE-B has been configured with qinq encapsulation. CE-A sends frames with a single tag of 100. The VLAN tag from CE-A must be passed transparently. CE-B is expecting a frame with a top tag of 200 and bottom tag of 100. Which of the following is the correct SAP id for PE-B?

Asap 1/1/1:200.100

Bsap 1/1/1:200*

Csap 1/1/1:*

Dsap 1/1/1:0*

Show Answer

Nokia 4A0-C02 Quiz:13 Topic:4 Questions:61-65