Huawei H12-261 Quiz 40 Topic 9 Questions 196-200

Question: 1

You are troubleshooting a frame relay problem with the serialO interface on one of your HW routers. When the interface is brought up, it stays up for a short time before it goes back down. You issue the show interface command, and from this you can see that your interface shows LMI status messages sent, but none received. What could be the problem?

AThere are too many input errors on the line.

BThe Frame-Relay Imi-type is set incorrectly.

CThere are too many configured sub-interfaces, causing the IDB limit to be exceeded.

DThe DCD is not set correctly for a Frame-Relay circuit.

EKeepalives are not set correctly on both ends.

Show Answer

Question: 2

What SNMP message type reports events to the NMS reliably?

AGet

BResponse

CInform

DTrap

EGet Bulk

Show Answer

Question: 3

Which of the following tools can be used when IS-IS filters routes?

Acommunity-filter

Baccess-list

Cpolicy-based-route

Das-path-filter

Show Answer

Question: 4

Two BGP peers connected through a routed firewall are unable to establish a peer relationship. What could be the most likely cause?

ABGP peers must be Layer 2-adjacent.

BEBGP multihop is not configured.

CThe firewall is not configured to allow IP protocol 89.

DThe firewall is not configured to allow UDP 179.

Show Answer

Question: 5

A new HW office needs to use its router as a DHCP server. Which of the following statements are true about configuring the DHCP Server to handle DHCP in this HW office? (Multiple Choice)

AConfigure Manual Bindings

BConfigure a DHCP address pool

CConfigure a DHCP server boot file

DExclude IP Addresses not to be used in DHCP scopes

EConfigure the timeout value for Ping Packets

Show Answer

Huawei H12-261 Quiz:40 Topic:9 Questions:196-200