Question: 1
The network administrator attempts to add interface G0/0/1 on Switch A to Eth-trunk 1, however the command fails. Which of the following may cause this?
Question: 2
A network requires a solution to allow 50 private IP addresses to be translated, however only a single public address is available for use. Which translation method can be used to support this requirement?
Question: 3
NAPT allows for multiple internal addresses to be mapped to a single public address. How does NAT distinguish between the different private addresses when mapping to the same public address?
Question: 4
Refer to the graphic. Host A is located in a private network. It is required that Host A not only be capable of routing traffic over the public network, but also that public users are able to actively communicate with Host A.
Which NAT translation method should be configured on the gateway?
Question: 5
Refer to the graphic. In the private network, RTA dynamically assigns a public address from the address pool to hosts without port translation. Host C wishes to access the public network while pool addresses are assigned to Host A and Host B. What will occur as a result?
