Cisco 350-401 Quiz 36 Topic 14 Questions 176-180

Question: 1

The following system log message is presented after a network administrator configures a GRE tunnel %TUN-RECURDOWN Interface Tunnel 0 temporarily disabled due to recursive routing. Why is Tunnel 0 disabled?

ABecause dynamic routing is not enabled

BBecause the tunnel cannot reach its tunnel destination

CBecause the best path to the tunnel destination is through the tunnel itself

DBecause the router cannot recursively identify its egress forwarding interface.

Show Answer

Question: 2

Which two methods are used to reduce the AP coverage area? (Choose two.)

AIncrease minimum mandatory data rate

BReduce AP transmit power

CDisable 2.4 GHz and use only 5 GHz.

DEnable Fastlane.

EReduce channel width from 40 MHz to 20 MHz

Show Answer

Question: 3

Refer to the exhibit.

q3_350-401

An engineer must assign an IP address of 192.168.1.1/24 to the GigabitEthemet1 interface. Which two commands must be added to the existing configuration to accomplish this task? (Choose two)

ARouter(config-vrf)#address-family ipv6

BRouter(config-if)Cip address 192.168.1.1 255.255.255.0

CRouter(config-vrf)Sip address 192.168.1.1 255.255.255.0

DRouter(config-if)=address-family ipv4

ERouter(config-vrf)#address-family ipv4

Show Answer

Question: 4

Based on the output below, which Python code shows the value of the "upTime" key?

q4_350-401

A)

q4_350-401

B)

q4_350-401

C)

q4_350-401

D)

q4_350-401

AOption A

BOption B

COption C

DOption D

Show Answer

Question: 5

What are two methods of ensuring that the multicast RPF check passes without changing the unicast routing table? (Choose two.)

Aimplementing static mroutes

Bdisabling BGP routing protocol

Cimplementing MBGP

Ddisabling the interface of the router back to the multicast source

Eimplementing OSPF routing protocol

Show Answer

Cisco 350-401 Quiz:36 Topic:14 Questions:176-180