Cisco 300-625 Quiz 6 Topic 11 Questions 26-30

Question: 1

Which condition requires using a device alias rather than a Fibre Channel alias?

AThe zone database must be distributed over the fabric.

BThe same alias must be used in zoning as well as DPVM.

CAll aliases being used are being configured in the same VSAN.

DAliases must be saved within a central database on the fabric.

Show Answer

Question: 2

A domain ID conflict is detected on a switch. Which action resolves the issue in the shortest possible time after the preferred domain ID is changed to a static domain ID?

AIssue an fcdomain disruptive restart.

BIssue an fcdomain nondisruptive restart.

CEnter the commands for a VSAN suspend / no-suspend.

DEnter the commands to complete a domain manager fast restart.

Show Answer

Question: 3

Refer to the exhibit.

q3_300-625

Refer to the exhibit. A network engineer must configure the SAN telemetry streaming feature to stream statistics from a Cisco MDS 9000 Series Switch to two external receivers with the IP addresses 192.168.1.4 and 192.168.1.5. Which two configurations accomplish this configuration? (Choose two)

AAdd IP address 192.168.1.5 port 50005 protocol gRPC encoding GPB under destination-group 100.

BAdd IP address 192.168.1.5 port 50005 protocol gRPC encoding GPB under destination-group 300.

CAdd dst-grp 200 under subscription 100.

DAdd dst grp 300 under subscription 200.

EAdd dst-grp 100 under subscription 200.

Show Answer

Question: 4

Refer to the exhibit.

q4_300-625

Refer to the exhibit. Device alias information must be merged for two fabrics. Which setting must match on both fabrics before the merge can be performed successfully?

Adevice-alias mode

Bsession

Cqos

Dsmart-zoning

Show Answer

Question: 5

Refer to the exhibit.

q5_300-625

Refer to the exhibits A storage network engineer activates a zoneset on MDS-A and verifies the successful activation (Exhibit 1) The engineer is then notified that there is a SAN outage (Exhibit 2) What is the cause of the outage?

AAnother network engineer activated zoneset ZoneSetMDS-B-VSAN100 on MDS-A.

BAnother network engineer issued the zone mode enhanced vsan 100 command on another switch in the fabric.

CAnother network engineer activated the zoneset ZoneSetMDS-B-VSAN100 command on another switch in the fabric.

DAnother network engineer issued the zone default-zone permit vsan 100 command on another switch in the fabric.

Show Answer

Cisco 300-625 Quiz:6 Topic:11 Questions:26-30