Cisco 300-615 Quiz 1 Topic 9 Questions 1-5

Question: 1

Refer to the exhibit. One of the vPC VTEPs fails to route VXLAN traffic to vPC connected hosts. When the issue was being diagnosed, it was discovered that the packets that were expected to be forwarded to the MAC address on the SWITCH-VTEP-1 are instead forwarded to the MAC address on SWITCH-VTEP-2 and then dropped. Which action resolves the issue?

AConfigure a distributed anycast gateway on both peers

BConfigure ip arp synchronize under the VPC domain on both peers

CConfigure peer-gateway under the VPC domain on both peers

DConfigure a different secondary IP address for one of the vPC peers

Show Answer

Question: 2

Refer to the exhibit. A network engineer creates an EEM script to trigger an SNMP notification when a user enters configuration mode, but the trap is not received when the condition is met. Which action resolves the issue?

AAppend action 2.0 event-default to the script

BAppend action 2.0 cli ''conf t'' to the script

CModify snmp-trap strdata ''Configuration changed'' to syslog msg Configuration changed

DModify cli match ''conf t'' to ''snmp match ''conf t''

Show Answer

Question: 3

Refer to the exhibit. A network engineer deploys scripts to the guest shell of a Cisco Nexus switch. The scripts fail to operate properly due to the limited CPU and file system resources that are assigned by default to the guest shell. The engineer allocated more memory and disk space to the guest shell, but the application continues to fail. Which action resolves the issue?

ADisable and enable bash shell

BReboot the guest shell

CRedeploy the bash shell

DUpgrade the guest shell

Show Answer

Question: 4

Refer to the exhibit. A functioning trunk port Ethernet1/48 exists between two identical Cisco Nexus 5000 Series Switches. The interfaces on the switches support the MACsec feature and are configured identically. To enable manual MACsec, an engineer adds the configuration shown in the exhibit to both sides of the trunk. The trunk port stops functioning. Which action should be taken to resolve the issue?

ADisable and then enable the port

BEnable the license for the trunk ports to support MACsec

CLower the MTU value to less than 9216 bytes

DConfigure the PMK with a length of 2048 bytes

Show Answer

Question: 5

Refer to the exhibit. A network engineer is troubleshooting a Cisco Nexus 5000 Series Switch. The interface between the server and the switch is nonoperational and is expected to operate at 10 Gbps. The drain rate of the interface is 3 Mbps. Which action resolves the issue?

AConfigure pause error-disable recovery

BEnable link level pause on the interface

CReset priority flow counters

DSet priority flow control pause

Show Answer

Cisco 300-615 Quiz:1 Topic:9 Questions:1-5