Cisco 300-515 Quiz 2 Topic 1 Questions 6-10

Question: 1

What do EVPN single-active and all-active have in common?

AThey are default gateway redundancy options.

BThey are multihoming mechanisms used for CE devices.

CThey are used to provide single connection from a CE device to a service provider.

DThey are both roles that a designated router can take when MPLS is used with EVPN.

Show Answer

Question: 2

A network engineer is implementing Layer 3 MPLS VPNs on Cisco IOS/IOS XE PE routers. Which PE-to-CE routing protocol requires a separate routing process to be created for each VRF?

ARIPv2

BOSPF

CBGP

DEIGRP

Show Answer

Question: 3

Which two frames can be configured on an Ethernet flow point? (Choose two.)

Aof a specific VLAN

Bwith different type of service values

Cwith identical type of service value

Dwith different class of service values

Ewith no tags

Show Answer

Question: 4

Which statement describes the no bgp default route-target filter command?

APrefixes that are received with route targets and distinguisher are accepted.

BPrefixes that are received with route targets and distinguisher are not accepted.

CPrefixes that are received with route targets that are not imported at the PE are not accepted.

DPrefixes that are received with route targets that are not imported at the PE are accepted.

Show Answer

Question: 5

Refer to the exhibit.

q5_300-515

A network operator is implementing EVPN IRB on PE1. Which two command placements enable the advertisement of Type 2 routes and what information do Type 2 routes contain? (Choose two.)

AThe operator adds in ''host-routing'' under the VRF EVPN.

BType 2 routes contain MAC/IP information.

CType 2 routes contain Ethernet Auto-Discovery information.

DThe operator adds in ''host-routing'' under the BVI651 interface.

EType 2 routes contain inclusive source-specific multicast route information.

Show Answer

Cisco 300-515 Quiz:2 Topic:1 Questions:6-10