Cisco 300-425 Quiz 6 Topic 8 Questions 26-30

Question: 1

A customer is concerned about mesh backhaul link security. Which level of encryption does the backhaul link use?

Ahash

BAES

CWEP

D3DES

Show Answer

Question: 2

An engineer must create data link redundancy for the company's Cisco Wireless LAN controller. The engineer has decided to configure LAG-based redundancy instead of port-based redundancy. Which three features of LAG-based redundancy influenced this decision? (Choose three.)

APackets are always sent out on the same port they are received on.

BAll interface traffic passes as long as one port is up.

CThe same port has multiple untagged dynamic interfaces.

DInterface connection to two separate nonstacked switches is available.

EFull bandwidth of all links is available.

FPorts are grouped into multiple LAGs.

Show Answer

Question: 3

An engineer must speed up the reauthentication delays that are being experienced on the wireless infrastructure by deploying a key-caching mechanism. Which mechanism must be configured?

APEAP

BFT

CPMF

DGTK-randomization

Show Answer

Question: 4

Which statement about AP failover priority for access points when configured with priority 1 or 4 is true?

AWhen configured with priority 1, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.

BWhen configured with priority 4, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.

CWhen configured with priority 4, the access point is assigned with the lowest priority level and it is marked as low. This access point fails over after other access points with the higher priority when there is primary controller failure.

DWhen configured with priority 1, the access point is assigned with the medium priority level and it is marked as medium. This access point fails over after other access points with the higher priority when there is primary controller failure.

Show Answer

Question: 5

An engineer must perform an assessment of a customer LAN for a future IEEE 802.llac Wave 2 wireless deployment. All access switches are Fast Ethernet-capable only, and the wired infrastructure between existing APs and access switches is based on the CAT 6A standard Which two actions provide maximum support of Osco 3800 Series access points? (Choose two)

AReplace the existing switches with gigabit switches with 10 G uplinks.

BEnsure that cable distances between access switches and APs are not longer than 55 meters.

CReplace the existing wiring infrastructure with the CAT-7E wiring standard.

DReplace the existing switches with mGig switches.

EEnsure that cable distances between access switches and APs are not longer than 100 meters

Show Answer

Cisco 300-425 Quiz:6 Topic:8 Questions:26-30