Cisco 300-410 Quiz 15 Topic 5 Questions 71-75

Question: 1

A DMVPN single hub topology is using IPsec + mGRE with OSPF. What should be configured on the hub to ensure it will be the designated router?

Atunnel interface of the hub with ip nhrp ospf dr

BOSPF priority to 0

Croute map to set the metrics of learned routes to 110

DOSPF priority greater than 1

Show Answer

Question: 2

Refer to the exhibit.

q2_300-410

The network administrator must mutually redistribute routes at the Chicago router to the LA and NewYork routers. The configuration of the Chicago router is this:

q2_300-410

After the configuration, the LA router receives all the NewYork routes, but NewYork router does not receive any LA routes. Which set of configurations fixes the problem on the Chicago router?

A)

q2_300-410

B)

q2_300-410

C)

q2_300-410

D)

q2_300-410

AOption A

BOption B

COption C

DOption D

Show Answer

Question: 3

What is a function of BFD?

Apeer recovery after a Layer 3 protocol adjacency failure

Bpeer recovery after a Layer 2 adjacency failure

Cfailure detection independent of routing protocols and media types

Dfailure detection dependent on routing protocols and media types

Show Answer

Question: 4

Refer to the exhibit.

q4_300-410

An engineer is troubleshooting BGP on a device but discovers that the clock on the device does not correspond to the time stamp of the log entries. Which action ensures consistency between the two times?

AConfigure the service timestamps log uptime command in global configuration mode.

BConfigure the logging clock synchronize command in global configuration mode.

CConfigure the service timestamps log datetime localtime command in global configuration mode.

DMake sure that the clock on the device is synchronized with an NTP server.

Show Answer

Question: 5

Refer to the exhibit.

q5_300-410

Refer to me exhibit. The hub and spoke are connected via two DMVPN tunnel interfaces The NHRP is configured and the tunnels are detected on the hub and the spoke Which configuration command adds an IPsec profile on both tunnel interfaces to encrypt traffic?

Atunnel protection ipsec profile DMVPN multipoint

Btunnel protection ipsec profile DMVPN tunnel1

Ctunnel protection ipsec profile DMVPN shared

Dtunnel protection ipsec profile DMVPN unique

Show Answer

Cisco 300-410 Quiz:15 Topic:5 Questions:71-75